Another week is over, so time for a recap of the progress on Ms. Scarlet. I was out of town until Friday so not much was accomplished other than clean-up and dismantling of my “Parts” SU H1 carbs.
Soak the entire set in EvapORust overnight.
Spray with Dawn and scrub with detailing brushes.
Soak in parts cleaner and spray with carb cleaner.
Check out a 1098 cylinder head’s suitability for use in Scarlet.
Sand and paint the heatshield.
Sand and paint the heater core box.
Next week I’ll finish the heater/blower components and pack away until I’m ready to install. Then start on removing the master cylinder and hydraulic lines.
Comments
You can follow this conversation by subscribing to the comment feed for this post.